Skip to product information
  • Vetonek Sombrilla jardín voladiza con palo de aluminio arena 400x300 cm

Voladized garden umbrella with aluminum stick 400x300 cm

400,00 €
400,00 € 450,19 €
You save 11% (50,19 €)
Tax included. Shipping calculated at checkout.

Description

This elegant blanket umbrella is a perfect choice to create some shade and protect from the harmful UV rays of the sun. Made of polyester with protection against ultraviolet rays that does not fade, the umbrella cover provides optimal protection against the sun and is easy to clean. It has a robust cross base to add stability. Our garden umbrella can be easily opened and closed simply by turning the post of the post. The angle of the cover can be adjusted by pushing and pulling the handle up and down. The central post can also be rotated in 360 degrees by means of the pedal. The strong steel post, along with the 8 robust rods, make the umbrella very stable and lasting. The article is easy to assemble. Keep in mind that we recommend treating the umbrella fabric with a waterproofing spray if it is subjected to heavy rains.

  • Roof color: white sand
  • Material: Fabric with PA + aluminum coating with powder coating
  • Total dimensions: 400 x 300 x 268 cm (length x width x high)
  • Cross base dimensions: 100 x 100 cm (length x wide)
  • Post dimensions: 7 x 5 cm (long x width)
  • With ventilation and crank system
  • 360 degree inclinable and rotating design
  • Includes 8 aluminum rods
  • Material: Polyester: 100%
It is important that any product mounted with any type of screw will press again 2 weeks after assembly and once every 3 months to guarantee stability during product useful. Do not completely tighten each screw until all screws are correctly fixed. Keep children outside the assembly area during assembly. Handle heavy pieces carefully. This product should only be used in firm and level terrain. This product is intended only for domestic use. Keep your hands away from the folding mechanism and mobile pieces to avoid possible injuries. Never use this umbrella without an adequate base on your place. Do not use this umbrella for periods of strong winds and rain. Otherwise, it can cause personal injuries and/or damage. Always close the umbrella and place the roof if the wind exceeds a "moderate breeze", if there are snowfalls or if it is raining. The product contains small parts that could represent a risk for young children. Keep small pieces out of the reach of children. This product is not a toy! Make sure children do not use parasol, awning or the basis to play or climb. Do not use open fire (for example, barbecues or garden grills) below or next to this product.

How much stone do I need?

How much stone do I need for the ground?

For shot and gravel song:
• ± 80kg per m², based on a 5cm layer.*For granulometries> 32mm a thicker layer is necessary.• Saca consumption: 1000kg = 0.625m³.
• Covering capacity: ± 12.5m² with a layer of 5 cm.

For pine cortex:
• ± 70L per m², based on a 5cm layer.
• Saca consumption: 1000L = ± 1m³ = ± 600kg
• Covering capacity: ± 14m² with a layer of 5 cm.

For volcanic, slate and chamota:
• ± 50kg per m², based on a 5cm layer.
• Saca consumption: 1000kg = ± 1m³
• Covering capacity: ± 20m² with a layer of 5 cm

How much stone do I need to fill a gabion?

Density of ± 1,650kg by 1m³.

The calculation is very simple to understand with an example, if you have a 100x50x30 cm gav. You have to make the following accounts:
1x0.5x0,3 = 0.15m³
0.15x1,650 = 247.50kg. stone.
*It is always good to calculate an extra 5%, since the gavions when filling them are a little and always enters some more stone than in the theoretical calculations.

Clarifications

ATTENTION!

Granulometries are sizes of sizes

Real sizes can vary slightly, since when talking, for example, 60-80mm stone, it means that the stones pass through a square mesh of 80x80mm. and do not go through a 60x60mm.
This 80x80 mesh can pass a 100mm stone. long and 65mm. wide so there may be a percentage of stones greater than 80 and less than 60mm.

Broken stones

On the other hand, in the stones of more than 60mm. There is a percentage of up to 10% stones that can be broken during classification, washing, loading and downloading, today we have no machinery that avoids those breaks.

In the photos you can see, only real products are seen, broken pieces have been removed.

Dust and sand in products

This product is not washed, so it contains dust, sand and even traces of other products due to processing and transport. This is not a problem when using it; The stone will be washed alone over time or can throw water before using it.