Skip to product information
  • Compresor de correas 100 L cabezal en V Cevik Pro - Vetonek
  • Compresor de correas 100 L cabezal en V Cevik Pro - Vetonek

Belt compressor 100 L - 3 HP and 336 L/min with V-head

420,42 €
420,42 € 429,00 €
You save 2% (8,58 €)
Tax included. Shipping calculated at checkout.
Envase

Belt compressor 100 L - 3 HP and 336 L/min with V-head

100-liter belt-driven compressor with V-twin pump head

It runs at 1,100 rpm, the lowest speed in the entire single-phase range. That is the factor that truly determines a compressor’s service life: fewer revolutions mean less friction, less heat, and a pump head that can work for fifteen years without problems.

It combines belt drive with a V-twin pump head and a 100-liter tank. It is the classic configuration of a fixed workshop compressor: plenty of reserve, constant flow of 336 L/min, and operation from a 230 V outlet, without the need for three-phase power.

✅ Main advantages

  • Only 1,100 rpm: the lowest speed in the single-phase range, and the one that lasts the longest.
  • Lubricated and repairable V-twin pump head.
  • 100-liter tank: long and spaced-out cycles.
  • 336 L/min sustained for multiple air outlets.
  • Single-phase: workshop power without special electrical installation.

🏗️ What it is for

  • Fixed air installation in an auto or bodywork workshop.
  • Extended daily use with pneumatic tools.
  • Spray painting and finishing work.
  • Carpentry, assembly, and industrial maintenance.

📋 Technical data sheet

  • Voltage: 230 V
  • Power: 3 HP
  • Maximum pressure: 8 bar
  • Flow rate: 336 L/min
  • Speed: 1,100 rpm
  • Tank capacity: 100 liters
  • Transmission: belt drive
  • Pump head: V-twin

💡 Professional tip: check the belt tension every six months. With your finger, at the midpoint between pulleys, it should give about one centimeter: if it slips, you lose flow without noticing and it gets glazed; if it’s too tight, you’ll damage the motor bearings. It’s a one-minute job, and almost nobody does it.