Ésera Double-Slope Wall Coping - Protects Both Sides with One Piece
Ésera Double-Slope Wall Coping: a two-slope U-shaped profile
Many copings leave one face of the wall unprotected, and water gets in through that exposed side, causing damp and deterioration. This piece has a U-shaped section and covers both faces of the wall with a single unit, and its top slopes both ways so water runs off instead of pooling.
✅ Key advantages
U-shaped design: protects both sides of the wall with a single piece.
Double slope: helps water run off and prevents pooling on the coping.
Rounded edge: greater thickness, a more attractive finish and better impact resistance.
High-performance concrete: good behaviour outdoors and through freeze-thaw cycles.
3 colours: Grey, White and Beige.
🏗️ Recommended applications
Party walls where both faces are visible.
Garden walls and flower-bed borders.
Capping for walls exposed to wind-driven rain.
Capping for unfinished block walls.
📋 Technical data sheet
Material: high-performance concrete.
Profile: U-shaped section with double slope.
Edge: rounded, extra thickness.
Piece length: 50 cm (2 pieces per linear metre).
Fitting width: 25 cm.
Colours: Grey, White and Beige.
🧰 Installation
Check the actual width of the finished wall at several points before starting.
Clean the top of the wall and remove any burrs that would stop the piece from seating properly.
Spread flexible bonding mortar on top of the wall, without reaching into the side skirts.
Fit the piece horizontally, without forcing it on edge, and adjust with a rubber mallet.
Leave a 3-5 mm joint and point it with elastic mortar.
Clean while fresh where the skirt meets the wall's masonry.
📦 Available formats
Single unit, in Grey, White and Beige.
💡 Professional tip: with U-shaped pieces, you can't correct the width on the fly. Before ordering material, measure the wall every two or three metres and go with the largest measurement; if the wall bulges in places, level it out first with guide strips and mortar. Forcing a U-shaped piece on edge is the fastest way to crack it at the skirt.
Frequently Asked Questions
¿Qué diferencia hay con el cubremuros en U estándar?
Este añade doble pendiente en la cara superior, en lugar de una superficie plana.
¿Por qué cubre las dos caras del muro?
Porque su sección en U baja por los dos laterales y los envuelve.
¿Qué ancho de muro admite?
Está concebido para muros de unos 25 cm de ancho terminado.
¿Qué es el canto romo?
Un borde redondeado, más resistente a golpes y más agradable a la vista.
¿Cuántas piezas por metro lineal?
Dos, cada pieza mide 50 cm.
¿Evita el estancamiento de agua?
Sí, la doble pendiente hace que el agua deslice hacia ambos lados.
¿Qué mortero uso?
Mortero de agarre flexible para exterior.
¿Se puede usar en muros revestidos?
Sí, siempre que el ancho final del muro coincida con el de la pieza.
¡Un servicio excelente! Personal muy amable, atento y profesional. Desde el primer momento te hacen sentir muy bien atendido y se nota que realmente se preocupan por la satisfacción del cliente. Una experiencia fantástica y totalmente recomendable. ¡Muchas gracias por la excelente atención!