Encina Wall Block - dry-stone look with Z-shaped interlock
Encina Wall Block: concrete with a dry-stacked stone look
Building a natural stone wall calls for a stonemason, time and budget. The Encina Wall Block achieves the same look with a precast concrete piece laid at a rate of 14 pieces per m² that reproduces the appearance of dry-stacked stone, with no visible mortar joints.
✅ Key advantages
Z-shaped interlock: the piece's geometry keys into place by simple contact, guiding each course and speeding up construction compared with traditional masonry.
Dry-stone look: irregular texture and layout, without the repeating pattern that gives away cheap precast pieces.
Complete system: the 59 × 10 × 14 cm block is finished off with the 47.5 × 12 × 4 cm wall cap and the 11 × 10 × 7 cm short piece for corners and wall ends.
Three factory tones: Albero, Caliza and Pirineos, colored throughout, not just on the surface.
Weather-resistant: vibrated concrete that withstands frost, rain and sun exposure.
Units/pallet: 60 for the 47.5 × 12 × 4 cm format and 45 for the 59 × 10 × 14 cm format.
🧰 Installation
Build a level, continuous concrete footing and let it cure before starting to build up.
Dry-lay the first course from corner to corner and fit the short pieces where needed.
Bed each course with decorative masonry joint mortar, using the Z-shaped lip as a guide.
Mix pieces from different pallets to spread out tone variation and avoid color patches.
Cap the wall with the wall-cap piece, giving it a slight slope towards the outside.
Clean off fresh mortar residue with a damp sponge before it hardens.
📦 Available formats
59 × 10 × 14 cm — single unit or pallet of 45 units.
47.5 × 12 × 4 cm (wall cap) — single unit or pallet of 60 units.
11 × 10 × 7 cm — single unit.
💡 Professional tip: the most common mistake is finishing the wall with the cap piece perfectly level. Give it a 1-2 cm fall towards the outside: if water sits on top of the coping it eventually seeps through the joint, and with the first frost it cracks the mortar. Also allow for 5% extra pieces for cuts and corners.
Frequently Asked Questions
¿Cuántos bloques necesito por metro cuadrado de muro?
14 piezas por m².
¿Hace falta cimentación?
Sí, una zapata corrida de hormigón nivelada bajo la primera hilada.
¿Con qué se pegan las piezas?
Con mortero de junta para albañilería decorativa.
¿El color es superficial?
No, va coloreado en masa, por lo que un golpe no deja ver el hormigón gris.
¿Sirve como muro de contención?
Solo en muretes de poca altura; para contenciones de tierra importantes hay que calcular estructura.
¿Se puede cortar?
Sí, con radial y disco de diamante.
¿Qué altura máxima recomendáis?
Muros bajos de cierre y jardinería; por encima de un metro conviene armar y consultar con técnico.
