Air lubricator for pneumatic tools

28,42 €
28,42 € 29,00 €
You save 2% (0,58 €)

Delivery in 3–15 days

Tax included. Shipping calculated at checkout.
Size

Air lubricator for pneumatic tools

Pneumatic tools that last for years, not months. This lubricator injects a fine oil mist into the air going to the tool, so that impact wrenches, drills or grinders always work lubricated, with less internal wear and more consistent power.

1/4" version with 42 cc bowl (0-12 bar) or 3/8" and 1/2" version with 68 cc bowl (0-16 bar, up to 60 °C), both with adjustable oil flow.

Key benefits

  • Constant lubrication: no need to remember to oil by hand.
  • Adjustable oil flow: dose it to suit the tool.
  • Two sizes: 42 cc or 68 cc bowl.
  • Longer service life: less wear on air motors.

What it is for

  • Workstations with impact wrenches, drills and pneumatic grinders.
  • Mechanical and tyre workshops.
  • Pneumatic machinery that needs lubricated air.

How to adjust it

Fill the bowl with pneumatic tool oil and set the drip rate with the tool running: a few drops per minute is enough for most tools. Too much oil does not lubricate any better; it just dirties the workpiece and the work area. Check the bowl level at the start of each day and top it up before it runs completely empty.

Technical features

  • 1/4": female thread, 42 cc bowl, 0-12 bar
  • 3/8" and 1/2": female thread, 68 cc bowl, 0-16 bar, max. 60 °C
  • Adjustment: adjustable oil flow
  • References: CA-921 · CA-929/12

Vetonek tip: do not fit a lubricator on the paint line: the oil would spoil the finish. Always use dedicated pneumatic tool oil and set the drip rate to the minimum the tool needs.

Frequently asked questions

What oil should I use?

Light oil specifically for pneumatic tools.

Where is it installed?

After the filter and regulator, as close to the tool as possible.

What is the bowl capacity?

42 cc on the 1/4" version and 68 cc on the 3/8" and 1/2" version.

Can I use it with a spray gun?

No, the oil would spoil the finish; for painting, use a line without a lubricator.

Can the amount of oil be adjusted?

Yes, the oil flow is adjustable.

Frequently Asked Questions

What oil should I use?

Light oil specifically for pneumatic tools.

Where is it installed?

After the filter and regulator, as close to the tool as possible.

What is the bowl capacity?

42 cc on the 1/4" version and 68 cc on the 3/8" and 1/2" version.

Can I use it with a spray gun?

No, the oil would spoil the finish; for painting, use a line without a lubricator.

Can the amount of oil be adjusted?

Yes, the oil flow is adjustable.