Drive roll for PROMIG500DP welder

28,42 €
28,42 € 29,00 €
You save 2% (0,58 €)

Delivery in 3–15 days

Tax included. Shipping calculated at checkout.
Model

Drive roll for PROMIG500DP welder

Continuous, jam-free wire feed on your PROMIG500DP, whatever the wire. On an industrial welder, a worn drive roll or one with the wrong groove means slipping wire, an arc that cuts out and production stoppages. This drive roll is the spare part for the wire feeder of the PROMIG500DP welder: it improves feed continuity and reduces jams.

Available for steel (0.8-1.0, 1.0-1.2 and 1.2-1.6 mm), flux-cored wire (1.0-1.2 and 1.2-1.6 mm) and aluminium (1.0-1.2 mm), so you have the right groove for every job.

Benefits

  • A groove for every wire: steel, flux-cored or aluminium.
  • Up to 1.6 mm: for industrial work with thick wires.
  • Fewer jams: constant drive and a more stable arc.
  • Easy replacement: direct replacement in the feeder.

What it is for

  • Replacing the worn drive roll on the PROMIG500DP.
  • Changing wire type or diameter.
  • Keeping spares on site so production never stops.

Technical specifications

  • Part: drive roll
  • Compatibility: PROMIG500DP
  • Steel: 0.8-1.0 · 1.0-1.2 · 1.2-1.6 mm
  • Flux-cored wire: 1.0-1.2 · 1.2-1.6 mm
  • Aluminium: 1.0-1.2 mm
  • Installation: easy replacement

Vetonek tip

When you change wire diameter, also change the contact tip and check the torch liner. Adjust the roller pressure just until the wire stops slipping: more pressure only deforms the wire.

Frequently asked questions

Which drive roll do I need?

The one that matches the wire type (steel, flux-cored or aluminium) and its diameter.

Is it suitable for other welders?

It is intended for the PROMIG500DP. For other PROMIG models we have specific drive rolls.

What is flux-cored wire?

It is a hollow wire with a flux core. It needs a specific drive roll to feed it without crushing it.

Can I use the steel drive roll for aluminium?

It is not recommended: aluminium is soft and deforms. Use the 1.0-1.2 mm aluminium version.

When should the drive roll be changed?

When the groove is worn, the wire slips even when you tighten it, or wire shavings appear in the feeder.

Frequently Asked Questions

Which drive roll do I need?

The one that matches the wire type (steel, flux-cored or aluminium) and its diameter.

Is it suitable for other welders?

It is intended for the PROMIG500DP. For other PROMIG models we have specific drive rolls.

What is flux-cored wire?

It is a hollow wire with a flux core. It needs a specific drive roll to feed it without crushing it.

Can I use the steel drive roll for aluminium?

It is not recommended: aluminium is soft and deforms. Use the 1.0-1.2 mm aluminium version.

When should the drive roll be changed?

When the groove is worn, the wire slips even when you tighten it, or wire shavings appear in the feeder.