Skip to product information

      Chuck for CP12-953 and CP12-961 pillar drills

      40,18 €
      40,18 € 41,00 €
      You save 2% (0,82 €)

      Delivery in 3–15 days

      Tax included. Shipping calculated at checkout.
      Packaging

      Chuck for CP12-953 and CP12-961 pillar drills

      Restore the precision of your pillar drill. Replacement chuck for the CP12-953 and CP12-961 pillar drills. A chuck with play makes the bit wobble and wander, leaving oval holes; replacing it restores the accuracy you expect from a pillar drill.

      It is a dedicated spare part for these two models, so it fits without adaptation and in a few minutes you are drilling again with the bit perfectly centred.

      Key benefits

      • Dedicated spare part: for CP12-953 and CP12-961 pillar drills.
      • Precise holes: the bit spins true again.
      • Direct fitting: no adapters needed.
      • Extends the life of the drill: without replacing the whole machine.

      What it's for

      • Replacing a chuck that has play, is damaged or does not tighten.
      • Machining, locksmith and carpentry workshops.
      • Pillar drill maintenance.

      How to fit it

      Unplug the drill and remove the old chuck. Thoroughly clean the spindle taper and the seat of the new chuck, fit it and seat it firmly. Do a test run without load using a straight bit to check there is no runout before starting work. Check the tightness from time to time if you work with large bits. With the new chuck you will notice the difference from the very first hole.

      Technical specifications

      • Type: replacement chuck
      • Compatible with: CP12-953 and CP12-961 pillar drills
      • Reference: CP12-909

      Vetonek tip: clean the spindle taper thoroughly before fitting the new chuck: a speck of dirt is enough to throw it off-centre. Always clamp the workpiece in a vice when drilling.

      Frequently asked questions

      Which drills is it for?

      For the CP12-953 and CP12-961 pillar drills.

      When should I replace it?

      When the bit no longer runs centred or the chuck does not tighten properly.

      Do I need adapters?

      No, it is the dedicated spare part for those two models.

      What should I do before fitting it?

      Thoroughly clean the spindle taper and the inside of the chuck so that it seats perfectly.

      Is it suitable for other drills?

      It is intended for the CP12-953 and CP12-961 models; for other machines, check the mounting type.

      Frequently Asked Questions

      Which drills is it for?

      For the CP12-953 and CP12-961 pillar drills.

      When should I replace it?

      When the bit no longer runs centred or the chuck does not tighten properly.

      Do I need adapters?

      No, it is the dedicated spare part for those two models.

      What should I do before fitting it?

      Thoroughly clean the spindle taper and the inside of the chuck so that it seats perfectly.

      Is it suitable for other drills?

      It is intended for the CP12-953 and CP12-961 models; for other machines, check the mounting type.