Aluminium drive roll for PROMIG 165 and 200 welders

23,52 €
23,52 € 24,00 €
You save 2% (0,48 €)

Delivery in 3–15 days

Tax included. Shipping calculated at checkout.
Packaging

Aluminium drive roll for PROMIG 165 and 200 welders

Weld aluminium with your PROMIG165 or PROMIG200 without the wire getting crushed or jammed. Aluminium wire is soft: with a steel drive roll it deforms, slips and ends up tangled in the feeder. This drive roll is specifically for 0.8 and 1.0 mm aluminium wire and is the spare part for the PROMIG165 and PROMIG200 MIG/MAG welders.

Its double-guide system gives more stable feeding of the soft aluminium wire, with smooth, constant drive that results in a more stable arc and more even beads. It is the key part for your wire-feed welder to handle aluminium as reliably as steel, with no stoppages from jams or deformed wire in the feeder.

Benefits

  • Aluminium-specific: drives the soft wire without crushing it.
  • Double guide: more stable feeding and fewer jams.
  • Two diameters: suitable for 0.8 and 1.0 mm wire.
  • Direct replacement: for PROMIG165 and PROMIG200.

What it is for

  • Setting up a PROMIG165 or PROMIG200 to weld aluminium.
  • Replacing a worn aluminium drive roll.
  • Repairs and fabrication of aluminium parts in the workshop.

Technical specifications

  • Part: aluminium drive roll
  • Wire: aluminium 0.8 and 1.0 mm
  • Compatibility: PROMIG165 and PROMIG200
  • System: double guide
  • Supplied as: single unit

Vetonek tip

With aluminium, set the roller pressure to the minimum that drives the wire without slipping: soft wire deforms easily. Also use aluminium contact tips and, if possible, a torch with a Teflon liner. Store aluminium wire in a dry, covered place to prevent it oxidising.

Frequently asked questions

Why an aluminium drive roll?

Aluminium is soft and needs a groove that drives it without crushing it.

Which welders is it for?

For the PROMIG165 and PROMIG200.

What wire diameters does it take?

0.8 and 1.0 mm aluminium wire.

What else do I need to weld aluminium?

Aluminium wire, specific contact tips, pure argon gas and, if possible, a torch with a Teflon liner.

Is it difficult to change?

No, it is replaced in the welder's wire feeder in a few minutes, without special tools.

Frequently Asked Questions

Why an aluminium drive roll?

Aluminium is soft and needs a groove that drives it without crushing it.

Which welders is it for?

For the PROMIG165 and PROMIG200.

What wire diameters does it take?

0.8 and 1.0 mm aluminium wire.

What else do I need to weld aluminium?

Aluminium wire, specific contact tips, pure argon gas and, if possible, a torch with a Teflon liner.

Is it difficult to change?

No, it is replaced in the welder's wire feeder in a few minutes, without special tools.