Cinca Smooth Wall Coping 1 m - 16 cm Flat Zone for Fencing and Balusters
Cinca Smooth Wall Coping 1 m: flat base for fencing and balusters
You want to fit a railing, a trellis or fencing on top of the wall, but the coping doesn't give you enough flat surface to fix it securely. This wall coping solves that with its 16 cm flat central strip, while the chamfered edges and built-in drip edge ensure optimal drainage and keep the façade clean.
✅ Key advantages
16 cm flat central strip: secure installation of metal fencing, trellises or balusters.
Built-in drip edge: minimises dirt and staining on the façade.
Partially chamfered surface: the bevelled edges give optimal water drainage.
Smooth finish: a contemporary look, with no rough texture.
1-metre piece: fewer joints and faster installation.
🏗️ Recommended applications
Enclosure walls with trellis or metal fencing on top.
Terrace parapets with an anchored railing.
Base walls for balustrades.
Plot enclosures on contemporary-style projects.
📋 Technical data sheet
Material: concrete with a smooth finish.
Profile: chamfered with a flat central strip and drip edge.
Flat strip: 16 cm.
Length: 1 metre (1 piece per linear metre).
Width: 30 cm.
Colours: White and Cement Grey.
🧰 Installation
Level the top of the wall and mark the centre line with a string.
Lay out the fencing's anchor points before positioning the pieces.
Spread flexible bonding mortar over the entire bearing surface.
Position the piece with two people, with the flat strip centred.
Leave a 3-5 mm joint, point it with elastic mortar and clean while fresh.
Wait 48 hours before drilling to anchor the fencing.
📦 Available formats
Single unit, in White and Cement Grey.
💡 Professional tip: before fitting the coping, mark out where the trellis posts will go and keep the joints clear of those points. Drilling into a joint is a guarantee the anchor will come loose: the resin has no continuous material to grip, and the post ends up moving in the wind. A 1-metre piece gives you plenty of room to position them well.
Frequently Asked Questions
¿Por qué necesito una franja plana?
Porque un remate redondeado o a dos aguas no da asiento para anclar un cerramiento con seguridad.
¿Cuánto mide esa franja?
16 cm de ancho, a lo largo de todo el metro de pieza.
¿Cuántas piezas por metro lineal?
Una.
¿Qué significa superficie parcialmente albardillada?
Que solo los bordes están biselados; el centro queda plano.
¿Cómo se ancla la celosía?
Con anclaje químico sobre la franja plana, nunca con taco de expansión.
¿Cuánto hay que esperar antes de perforar?
Al menos 48 horas desde la colocación.
¿Qué mortero uso?
Mortero de agarre flexible para exterior.
¿Hay que limpiar el mortero en fresco?
Sí, sobre acabado liso el velo de cemento seco es difícil de retirar.
