Ésera Wall Coping - U-Shaped Profile That Seals the Wall on Three Sides
Ésera Wall Coping: the U-shaped profile that wraps around the wall
A wall with no coping lets water in through the sides and top, and the result is damp, moss and cracks that gradually weaken the structure. The Ésera Wall Coping has a U-shaped cross-section: it wraps around the wall completely, sealing the top and both side faces with a single piece.
✅ Key advantages
U-shaped section: wraps the wall completely and seals both sides against damp.
Drip edge at the base: keeps rainwater off the wall and protects the façade from run-off.
Extra thickness: more strength and a more elegant finish than a standard coping.
No need to point the sides: the skirt covers the join between coping and masonry.
4 sizes: from 15 to 35.5 cm wide, in Grey, White and Beige.
🏗️ Recommended applications
Garden walls and flower-bed borders.
Narrow enclosure walls and boundaries between plots.
Capping for walls exposed to driving rain.
Capping for unfinished block walls.
📋 Technical data sheet
Material: high-quality concrete.
Profile: U-shaped section with drip edge at the base.
Measure the actual width of the finished wall, including any cladding, and choose the size that fits.
Clean the top of the wall and remove any mortar burrs that would stop the piece from seating properly.
Spread flexible bonding mortar on top of the wall, without reaching the side skirts.
Fit the piece horizontally, without forcing it on edge, and tap with a rubber mallet.
Leave a 3-5 mm joint between pieces and point with elastic mortar.
Clean off excess while fresh, especially where the skirt meets the wall.
📦 Available formats
Single unit.
Full pallet.
💡 Professional tip: measure the wall at several points before ordering, not just one. The U-shaped piece has to fit, and unlike a flat slab it won't forgive an extra centimetre: if the wall is slightly wider at one point, the piece won't go on there and you're left with an incomplete finish. If the measurements vary, choose the next size up and fill the gap with mortar.
Frequently Asked Questions
¿Qué es un cubremuros en U?
Una pieza que envuelve el muro por arriba y por los dos laterales, en lugar de apoyarse solo encima.
¿Qué medida necesito?
La del ancho real del muro, ya que la pieza tiene que encajar sobre él.
¿Qué pasa si el muro es más ancho que la pieza?
No entra: mide siempre el muro terminado, con revestimiento incluido.
¿Qué significan las cifras 6 y 2?
La altura del faldón lateral y su espesor.
¿Cuántas piezas por metro lineal?
Dos, cada pieza mide 50 cm.
¿Protege mejor que una albardilla?
En muros estrechos sí, porque cubre también los laterales.
¿Qué mortero uso?
Mortero de agarre flexible para exterior.
¿Se puede usar en muros ya revestidos?
Sí, siempre que el ancho final coincida con el de la pieza.
