Segre Wall Coping End Piece - Drip Edge on 3 Sides Prevents Leaks
Segre Wall Coping End Piece: closing off the double-slope coping
The running coping protects the wall's two long sides, but leaves the end face exposed, and that's exactly where wind-driven rain gets in and causes damp and cracks. The Segre Wall Coping End Piece has a drip edge on three of its four sides, so the end of the wall and the top of the pillar are fully sealed.
✅ Key advantages
Drip edge on three sides: prevents leaks through the end face, the most exposed part of the coping.
Made to match: fits the coping model you're installing.
8 sizes and 3 colours: an end piece for every width in the range, with no cutting.
6.5 kg per unit: light to handle, even up on the wall.
Double-slope profile: the slope continues the course's without a step.
🏗️ Recommended applications
Closing the free end of enclosure walls.
Capping fence and entrance pillars.
Starting and finishing terrace parapets.
Capping exposed retaining walls.
📋 Technical data sheet
Material: high-quality concrete.
Profile: end coping with drip edge on three sides.
Consumption: one piece per free wall end and one per pillar.
🧰 Installation
Lay the running coping first and leave the end gap free.
Dry-check that the end piece's slope continues the course's without a step.
Spread flexible bonding mortar over the bearing surface.
Orient the blank face towards the inside of the wall and the drip-edged end facing out.
Leave a 3-5 mm joint with the adjoining piece and point it with elastic mortar.
Clean while fresh and protect from rain for 24 hours.
📦 Available formats
Single unit, in the 8 sizes and 3 colours.
💡 Professional tip: count the end pieces before ordering, not after. A wall with two free ends and three pillars needs five end pieces, and on site people almost always order one. Since they're supplied as single units rather than by the pallet, forgetting one means leaving the wall open until the next delivery.
Frequently Asked Questions
¿Para qué sirve esta pieza?
Para cerrar el extremo libre de una hilada de albardilla o coronar un pilar.
¿En qué se diferencia de la albardilla corrida?
Lleva goterón también en el testero, la cara que queda vista al final del muro.
¿Cuántas necesito?
Una por cada extremo libre de muro y una por pilar.
¿Qué medida pido?
La misma que la albardilla corrida, para que el vuelo y la pendiente casen.
¿Cuánto pesa?
Unos 6,5 kg por unidad.
¿Se sirve en palet?
Se vende por unidad, ya que se consume en cantidades pequeñas.
¿Combina con el resto de la gama?
Sí, comparte colores y perfil con la albardilla corrida.
¿Cómo se coloca?
Con mortero de agarre flexible, igual que la albardilla corrida.
