Skip to product information
  • Vetonek Lámparas solares esféricas de exterior 8 uds LED RGB 15 cm

External spherical solar lamps 8 units RGB 15 cm

99,22 €
99,22 € 111,67 €
You save 11% (12,45 €)
Tax included. Shipping calculated at checkout.
Size
Color

Description

Our spherical LED solar lamp is equipped with an AAA battery that is loaded with solar energy during the day and automatically turns on when it darkens. It presents a color change in the light and is the perfect decorative lighting for gardens, patios, paths, entries of vehicles, etc. With two LED of 0.06 watts inside, the solar lamp can provide a lighting of 0.12 watts. During the day, the light turns the day light into electricity and recharges the battery. At dusk, it automatically turns on and It works with the electricity stored during the day. The duration of the light depends on the amount of diurnal light stored. The solar lamp saves energy and requires little maintenance. Thank you to the assembly materials included, exterior sunlight is easy to install. Delivery includes 8 ball solar lamps.

  • Color: White
  • Material: polypropylene
  • Ball diameter: 15 cm
  • Tube length: 32 cm
  • Power supply: solar
  • Contains 2 LED (2 x 0.06 w) per piece
  • With pre-installed rechargeable AAA (1.2V / Ni-MH 600 mAh)
  • Degree of protection: IP 44
  • Delivery includes 8 ball solar lamps.
This product should not be discarded along with other domestic waste in the European Union.

How much stone do I need?

How much stone do I need for the ground?

For shot and gravel song:
• ± 80kg per m², based on a 5cm layer.*For granulometries> 32mm a thicker layer is necessary.• Saca consumption: 1000kg = 0.625m³.
• Covering capacity: ± 12.5m² with a layer of 5 cm.

For pine cortex:
• ± 70L per m², based on a 5cm layer.
• Saca consumption: 1000L = ± 1m³ = ± 600kg
• Covering capacity: ± 14m² with a layer of 5 cm.

For volcanic, slate and chamota:
• ± 50kg per m², based on a 5cm layer.
• Saca consumption: 1000kg = ± 1m³
• Covering capacity: ± 20m² with a layer of 5 cm

How much stone do I need to fill a gabion?

Density of ± 1,650kg by 1m³.

The calculation is very simple to understand with an example, if you have a 100x50x30 cm gav. You have to make the following accounts:
1x0.5x0,3 = 0.15m³
0.15x1,650 = 247.50kg. stone.
*It is always good to calculate an extra 5%, since the gavions when filling them are a little and always enters some more stone than in the theoretical calculations.

Clarifications

ATTENTION!

Granulometries are sizes of sizes

Real sizes can vary slightly, since when talking, for example, 60-80mm stone, it means that the stones pass through a square mesh of 80x80mm. and do not go through a 60x60mm.
This 80x80 mesh can pass a 100mm stone. long and 65mm. wide so there may be a percentage of stones greater than 80 and less than 60mm.

Broken stones

On the other hand, in the stones of more than 60mm. There is a percentage of up to 10% stones that can be broken during classification, washing, loading and downloading, today we have no machinery that avoids those breaks.

In the photos you can see, only real products are seen, broken pieces have been removed.

Dust and sand in products

This product is not washed, so it contains dust, sand and even traces of other products due to processing and transport. This is not a problem when using it; The stone will be washed alone over time or can throw water before using it.